Toshiba T1960CT Maintenance Manual page 130

6. Secure the lower metal plate with two M2.5x8 screws (Figure 4-20).
7. Turn the assembly over, and place the lower system board assembly into the
computer's chassis, inserting the DC IN jack into the opening on the left side of
the chassis (Figure 4-19).
CAUTION: When you install the lower system board assembly, be careful to
thread the FDD cable through the FDD cable hole.
8. Secure the two M2.5x10 screws by the power supply circuits, and connect the
FDD cable to PJ202 (Figures 4-18 and 4-19).
9. Secure the M2.5x6 screw on the bottom of the unit (Figure 4-19).
10. Set the RTC battery in the RTC battery holder on the middle frame assembly
(Figure 4-18).
11. Set the PCMCIA expansion slot cover in place and secure it with two M2.5x6
screws.
12. Install the upper system board, display assembly, display mask, HDD, keyboard,
top cover, optional PCMCIA card, optional memory card and battery pack as
described in Sections 4.9, 4.8, 4.12, and 4.7 through 4.2.
4-26
T1960CS/T1960CT