Toshiba T1960CT Maintenance Manual page 42

Procedure 4 Connector Check
The Display unit has an LCD module, FL, Display switch, and FL inverter board. The FL and
FL inverter board are connected by two cables. The LCD module and system board are
connected by two signal cables as shown below. Any of these cables may be disconnected.
Disassemble the display unit and check the following cable connections. Refer to Chapter 4,
Replacement Procedures, for more information about how to disassemble the computer.
Figure 2-3 T1960CS Display Connection
Figure 2-4 T1960CT Display Connection
If any of these cables are not connected, firmly reconnect them and repeat Procedures 1 and 2.
If the problem still exists, perform Procedure 5.
2-25
T1960CS/T1960CT