Toshiba T1960CT Maintenance Manual page 121

Installing the Hard Disk Drive and Backup Battery
To install the hard disk drive and backup battery, follow the steps below and refer to Figures
4-9 through 4-13.
1. Secure the bracket with the four flat-head M3x4 screws (Figure 4-12).
2. Connect the backup battery cable to PJ503 (Figure 4-10).
3. Place the HDD into the HDD slot, and slide the drive to the back. Make sure the
HDD connector connects to PJ203 on the lower system board correctly as shown
in Figure 4-13.
Figure 4-13 Connecting the HDD to the System Board
4. Route the backup battery cable in the space between the HDD and the battery
cable insulator, then place the backup battery in the backup battery slot (Figure 4-
10).
5. Secure the M2.5x6 screw at the front of the HDD (Figure 4-11).
6. Set the keyboard base plate in place and secure it with the five M2.5x6 screws
(Figure 4-9).
7. Replace the tape next to the keyboard connector (PJ4) (Figure 4-9).
8. Install the keyboard, top cover, optional PCMCIA card, optional memory card and
battery pack as described in Sections 4.6 through 4.2.
T1960CS/T1960CT
4-17