Display Assembly - Toshiba T1960CT Maintenance Manual

4.8

Display Assembly

Removing the Display Assembly
To remove the T1960CS/T1960CT's display assembly, follow the steps below and refer to
Figures 4-14 through 4-16.
1. Turn off the power to the computer, and, if attached, disconnect the AC adapter,
power cord and all external cables connected to the computer.
2. Remove the battery pack, optional memory card, optional PCMCIA card, top
cover, keyboard, and keyboard base plate as described in Sections 4.2 through 4.7.
3. Set the display unit at a 90º angle to the base and remove the two hinge covers
from the left and right hinges (Figure 4-14).
4. Remove the display mask as described in Section 4.12.
5. Remove the four M2.5x8 silver screws and two M2.5x10 screws on the system
board cover (Figure 4-15). Note that the M2.5x8 screw under the left hinge
secures the ground wire.
6. Peel back the clear plastic insulator covering the display cable and lift out the
system board cover. As you lift the cover, place your fingers under the right side
to keep the memory card housing intact.
4-18
Figure 4-14 Removing the Hinge Covers
T1960CS/T1960CT