Toshiba T1960CT Maintenance Manual page 148

Installing the T1960CT Fluorescent Lamp
To install the T1960CT's fluorescent lamp, follow the steps below and refer to Figures 4-36
to 4-38. Note that there are separate grooves for the lamp and its white cable.
1. Slip the lamp's plastic shield between the lamp and its white cable and lay the
lamp into its groove.
2. Lay the cable into its groove, pressing down gently so that it is held in place by the
small tongues in the groove.
3. Route the white and blue cables as shown in Figure 4-38. Make sure the cables
are pressed down snugly so they will not be pinched by other components.
4. Lay the metal cover on the LCD panel making sure the latches marked by circles
in Figure 4-37 fit into their corresponding notches on the LCD panel. First, fit the
larger latch at the center of the edge facing the inverter board into its notch,
which should guide the other fittings into position.
5. Slide the metal cover back into place to secure the latches.
6. Secure the metal cover with six M2x4 screws (Figure 4-36).
7. Install the LCD module, FL inverter board, display mask, top cover, optional
PCMCIA card, optional memory card and battery pack as described in Sections
4.17, 4.16, 4.12, 4.5, 4,4, 4.3 and 4.2.
4-44
T1960CS/T1960CT