Toshiba T1960CT Maintenance Manual page 83

1. All track FORMAT
Pressing 1 selects "All track FORMAT," which formats the entire disk.
[All track FORMAT]
Drive
Cylinder :
Head
Sector
<<< Model name =
The following prompts appear at the bottom of the screen in succession:
(a) Select a drive number and press Enter . The following message appears:
(b) Select an interleave number (1 ~ 8) and press Enter . Pressing only
Enter selects 1.
(c) Bad track register
The Bad Track register prompt will appear as shown below. Enter the
cylinder and head numbers of the bad tracks and press Enter . Note that
if there are no bad tracks, pressing Enter alone is the same as executing
All Track Format described in Item (d) below.
[ WARNING : Current DISK data will be
Press Bad cylinder number (dddd)] key ?
Press Bad head number (dd)] key ?
Enter the cylinder and head number in the format above in decimal
notation. Repeat for each bad track you want to format.
After entering the bad tracks, press Enter to execute the format.
(d) All track format
All tracks are formatted as good tracks except those registered as bad
tracks in Item (c) above, or those identified as bad tracks in the track
verification process described in Item (e) below.
3-40
: #1 = HDD
XXXX
: XX
: XX
>>>
Drive number select (1:#1,2:#2) ?
Interleave number (1/1 ~ 8) ?
completely destroyed ]
#2 = Non
T1960CS/T1960CT