Toshiba T1960CT Maintenance Manual page 129

10. Remove the two M2x8 screws on the PCMCIA connector, and two M2.5x8
silver screws on the lower system board (Figure 4-21).
11. Lift off the PCMCIA card ejector.
12. Separate the lower system board from the middle frame assembly.
13. Lift out the PCMCIA frame assembly.
Installing the Lower System Board and RTC Battery
To install the T1960CS/T1960CT's lower system board and RTC battery, follow the steps
below and refer to Figures 4-18 through 4-21.
1. Insert the PCMCIA frame assembly into the middle frame assembly.
2. Slide the lower system board into the middle frame assembly from left to right,
making certain that the DC IN jack fits into the hole on the right side of the middle
frame assembly.
3. Place the PCMCIA card ejector on the PCMCIA frame assembly. The card
ejector fits inside the walls of the PCMCIA frame assembly and hooks into the
holes on the PCMCIA connector.
4. Secure the two M2x8 screws on the PCMCIA connector and two M2.5x8 silver
screws on the lower system board (Figure 21).
5. Holding the PCMCIA ejector button over the opening in the lower metal plate,
place the metal plate onto the lower system board. Work the ejector button so
that it moves the card ejector plate back and forth (Figure 4-20).
T1960CS/T1960CT
Figure 4-21 Removing the Lower System Board
4-25