Toshiba T1960CT Maintenance Manual page 128

5. Remove the M2.5x6 silver screw from the bottom of the computer (Figure 4-19).
6. Remove the two 2.5x10 screws located next to the power supply circuits on the
lower system board (Figure 4-19).
7. Open the PCMCIA expansion slot cover on the right side of the computer, remove
the two M2.5x6 screws securing the cover, then remove the cover.
8. Lift up the right side of the lower system board assembly and slide the assembly
to the right to release the DC IN jack on the left side of the board, then lift out the
assembly.
CAUTION: When you remove the lower system board assembly, carefully slide
the FDD cable out of the hole on the middle frame assembly.
Figure 4-19 Removing the Lower System Board Assembly
9. Turn the lower system board assembly over, remove the two M2.5x8 silver
screws, then lift off the lower metal plate and PCMCIA ejector button (Figure
4-20).
4-24
Figure 4-20 Removing the Lower Metal Plate
T1960CS/T1960CT