Display Mask Removal - Toshiba Tecra M1 Series Field Replaceable Unit Documentation

FIELD REPLACEABLE UNIT DOCUMENTATION

14.1" DISPLAY MASK REMOVAL

Mask seals
1. Remove two mask seals and two rubber seals on
the display mask using a pair of fine-tipped tweezers.
2. Remove four M2.5x6 black flat head screws securing
the display mask.
3. There are 22 latches securing the display mask.
Carefully insert your fingers between the mask and the
LCD panel and pry open the latches starting from the
six top latches, to the five latches on each right
and left sides, ending with the bottom seven latches.
Tecra
M1 Series
TOSHIBA
Tough Enough for Today's World.
TM
FL INVERTER AND 14.1" LCD REMOVAL
Mask
seals
M2x3
silver
screws
LCD/
FL cable
FL inverter board
1. Remove one M2x3 silver flat head screw securing
the FL inverter board.
2. Carefully lift up the FL inverter board and
disconnect the LCD/FL cable from CN1 and the
FL cable from CN2.
3. Remove four mask seals to expose four screws
securing the LCD module assembly.
4. Remove four M2X3 silver flat head screws
securing the LCD module assembly.
5. Carefully rotate out the top of the LCD module
enough to access the display cable
6. Peel off the tape securing the LCD/FL cable and
disconnect the cable.
7. Remove four M2x3 silver flat head screws
securing the right and left LCD brackets.
LCD module
Mask
seals
M2x3
silver
screws
M2x3 silver screw FL cable