Toshiba T1960CT Maintenance Manual page 31

UPDATE
Procedure 3 Printer Port LED Check on Resume Mode
The printer port LED displays the IRT status and test status by turning lights on and off as an
eight-digit binary value for resume mode.
NOTE: When you perform this check, the external FDD/PRT option in the SETUP
program must be set to PRT and set to resume mode.
To use the printer port LED follow these steps:
1. Turn on the T1960CS/T1960CT's power, then set it to resume mode.
2. Turn off the computer.
3. Plug the printer port LED into the PRT/FDD connector.
4. Turn on the computer.
5. Read the LED status from left to right as you face the back of the computer.
6. Convert the status from binary to hexadecimal notation.
7. If the final LED status is FFh (normal status), go to Procedure 4.
8. If the final LED status matches any of the test status values in Table 2-2, go to
Procedure 5.
Table 2-2 Printer Port LED Resume Mode Error Statuses
Error Status
00H RAM BIOS error
F0H Press the reset switch.
F1H Suspend process error (The system will suspend while FDD is accessed, etc.)
F2H The system has optional ROM, or optional card (CGA, MDA).
F4H Backup RAM checksum error
F5H Main memory checksum error
F6H Video RAM checksum error
F7H Extended memory checksum error
F8H Backup RAM checksum error
F9H Main memory checksum error
FAH Video RAM checksum error
FBH Extended memory checksum error
FDH Card modem error (The card modem will be removed while the system is in
resume, etc.)
FEH Password error (The password will be erased before it is suspended.)
2-14
Meaning of Status
T1960CS/T1960CT