4.15 T1960CS Fluorescent Lamp (FL)
CAUTION: When you remove the FL, be careful not to let any dust or other foreign
matter enter the display panel components.
Removing the T1960CS FL
To remove the T1960CS's FL, follow the steps below and refer to Figures 4-29 through 4-31.
1.
Turn off the power to the computer, and, if attached, disconnect the AC adapter,
power cord and all external cables connected to the computer.
2.
Remove the battery pack, optional memory card, optional PCMCIA card, top
cover, display mask, display assembly, FL inverter board, and LCD module as
described in Sections 4.2, 4.3, 4.4, 4.5, 4.12, 4.8, 4.13, and 4.14.
3.
Lay the color LCD module face down and use needle-nose pliers to unbend the
16 latches holding the front and back frames together. Then lift the unit out of the
front frame (Figure 4-29).
Figure 4-29 Unbending the Color LCD Module Latches
4-34
T1960CS/T1960CT