Arctic Cat 2013 Prowler XT Service Manual page 99

22. Place tab-washer onto the sprocket making sure it
covers the pin in the alignment hole.
CAUTION
Care must be taken that the tab-washer is installed cor-
rectly to cover the alignment hole on the sprocket. If the
alignment pin falls out, severe engine damage will
result.
23. Install the first cap screw (threads coated with red
Loctite #271) securing the sprocket and tab-washer
to the camshaft. Tighten only until snug.
24. Rotate the crankshaft until the second cap screw
securing the sprocket to the camshaft can be
installed; then install the cap screw (threads coated
with red Loctite #271) and tighten to 11 ft-lb. Bend
the tab to secure the cap screw.
3-72
25. Rotate the crankshaft until the first cap screw (from
step 23) can be addressed; then tighten to 11 ft-lb.
ATV-1027
Bend the tab to secure the cap screw.
26. Place the C-rings into position in their grooves in the
cylinder heads.
GZ195
27. Install the cylinder head plugs in the cylinder heads
with the open end facing downward and toward the
inside.
The open end of the plug must be positioned downward.
GZ193
CAUTION
CD465
GZ194
CC012D