Arctic Cat 2013 Prowler XT Service Manual page 86

 NOTE: Loop the chain over the cylinder head and
secure it to keep it from falling into the crankcase.
8. Remove the five nuts securing the cylinder head to
the cylinder; then remove the four cylinder head cap
screws and washers.
 NOTE: Removing the starter will simplify removal of
the front cylinder base nuts.
CC266D
9. Remove the cylinder head from the cylinder, remove
the gasket, and account for two alignment pins; then
remove the cam chain guide.
GZ408
10. If the remaining cylinder head is to be serviced,
apply tension to the loose timing chain and rotate the
second cylinder to top-dead-center of the compres-
sion stroke; then repeat steps 2-9 on the other cylin-
der head.
GZ136A

To service valves and cylinder head, see Servicing
Top-Side Components sub-section.

To inspect cam chain guide, see Servicing Top-Side
Components sub-section.
AT THIS POINT
AT THIS POINT
GZ132B
3
GZ151
GZ161
3-59