Arctic Cat 2013 Prowler XT Service Manual page 120

6. Remove the oil seal from the oil pump cover.
Assembling
1. Install a new oil seal into the oil pump cover; then
coat the lips of the seal with grease and install the
pump driveshaft from the seal side.
2. Noting the reference dots on the gerotor set, separate
the inner rotor from the outer rotor and with the ref-
erence dot directed toward the oil pump cover, place
the rotor on the shaft; then install the drive pin and
push the shaft into the rotor.
GZ354A
3. With the outer rotor reference dot directed toward the
GZ365
oil pump cover, install the rotor onto the inner rotor.
4. Place a new O-ring seal on the outside of the oil
pump cover. The oil pump assembly is now ready for
assembly into the crankcase.
GZ359
GZ356
3
GZ363
GZ360
GZ362
3-93