Arctic Cat 2013 Prowler XT Service Manual page 113

CAUTION
When installed correctly, the green alignment dot (or the
word OUTSIDE) on the one-way clutch is visible.
7. Place the clutch cover/clutch housing assembly into
position on the crankcase; then secure with the cap
screws. Tighten in a crisscross pattern to 8 ft-lb.
8. Making sure the alignment pins are correctly
installed, place a bead of silicone sealant on the mat-
ing surfaces and install the V-belt cover. Secure with
the cap screws tightened to 8 ft-lb.
3-86
GZ247
9. Place the driven pulley assembly into position and
secure with the nut (coated with red Loctite #271).
Tighten to 80 ft-lb.
10. Slide the fixed drive face onto the clutch shaft.
11. Spread the faces of the driven pulley by threading in
a cap screw; then when the faces are separated, insert
GZ246B
the belt and push down between the faces.
12. Place the V-belt into position on the driven pulley
and over the front shaft.
GZ263B
GZ244A
GZ066
GZ065A