Arctic Cat 2013 Prowler XT Service Manual page 195

Cleaning and Inspecting
1. Wash all parts in parts cleaning solvent and dry with
compressed air.
! WARNING
Always wear safety glasses when working with com-
pressed air.
2. Clean all gasket material and sealant from mating
surfaces.
3. Inspect bearings, shafts, and housing for excessive
wear, cracks, or discoloration.
4. Inspect the clutch basket (XTZ) for wear in splines
or cracks in the housing.
5. Inspect the clutch pack (XTZ) for signs of discolor-
ation.
 NOTE: The clutch pack is not a serviceable compo-
nent. If worn, discolored, or damaged in any way, it
must be replaced.
Assembling/Installing
1. Install a new bearing into the input housing and
secure with the snap ring (flat side directed away
from bearing).
2. Using a suitable seal driver, install a new oil seal into
the front of the input housing until the seal is flush
with the housing.
6-22
3. Apply grease to the lips of the oil seal; then install
the input shaft into the input bearing and housing.
GZ178A
4. Install the clutch basket (XTZ) onto the input shaft
and secure with the snap ring (flat side directed out-
ward); then install the clutch pack into the basket.
5. Using a new gasket, install the assembled rear drive
input shaft/housing onto the rear drive gear case and
secure with the three cap screws. Tighten to 23 ft-lb.

For servicing the input shaft, pinion gear, needle bear-
ing, and axle seal, see Front Differential in this section.
GZ184
INSTALLING
1. Slide the gear case into position down through the
upper-left side of the frame; then align the driveline
splines to the differential input coupler and engage
the driveshaft and differential.
AT THIS POINT
GZ182A
GZ179A
GZ176