Arctic Cat 2013 Prowler XT Service Manual page 127

5. Tighten the 6 mm cap screws to 8 ft-lb and the 8 mm
cap screws to 20 ft-lb using the pattern shown and
turning the shafts frequently to ensure there is no
binding.
 NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
 NOTE: Cap screw number eight (8) is installed from
the right side.
 NOTE: If the secondary drive/driven assemblies
have been disassembled, refer to Servicing Center
Crankcase Components sub-section for proper gear
tooth contact and backlash.
6. Install the locating ring in the crankcase assembly;
then install the secondary driven shaft assembly and
secondary drive assembly making sure the locating
ring and bearing engage correctly.
3-100
GZ342
7. Make sure the locating pins on the front and rear
bearings are correctly seated in the crankcase.
8. Install two alignment pins into the upper crankcase
assembly; then apply a thin bead of silicone sealant
to the lower crankcase cover.
GZ457A
9. Carefully place the lower crankcase cover onto the
joined crankcase halves; then secure with the cap
screws. Tighten the 6 mm cap screws to 8 ft-lb and
the 8 mm cap screws to 20 ft-lb.
GZ269A
GZ448A
GZ452A
GZ451