Arctic Cat 2013 Prowler XT Service Manual page 24

2. Slide brake caliper assembly over the brake disc and
into position on the rear drive housing; then secure
the caliper with new "patch-lock" cap screws tight-
ened to 20 ft-lb.
3. Connect the parking brake cable (see Adjusting in
this sub-section).
4. Adjust the parking brake (see Adjusting in this
sub-section).
5. Connect the lift support to the cargo box.
 NOTE: Whenever installing new pads, the new pads
must be burnished (see Burnishing Brake Pads in
this section).
MEASURING/REPLACING BRAKE
PADS (XTZ)
 NOTE: The brake pads should be replaced as a set.
1. Disconnect the parking brake cable from the actuator
arm. Account for a flat washer.
2. Remove the two cap screws and nuts securing the
cable support to the brake caliper.
3. Remove the two cap screws securing the brake cali-
per to the gear case housing; then remove the caliper
assembly from the vehicle.
4. Remove the two lock nuts (A) from the brake pad
anchor bolts; then remove the brake pads (B).
Account for two springs and spacers (C).
5. Install the new brake pads and anchor bolts with
springs and spacers; then secure with new lock nuts.
PR681A
6. Install the brake caliper onto the gear case housing
mounting bracket; then secure with two new
patch-lock
"
PR677A
cap screws and tighten to 20 ft-lb.
"
PR683A
2
PR678A
PR679
2-13