Arctic Cat 2013 Prowler XT Service Manual page 77

10. Install the throttle body and tighten the intake boot
clamp to 30 in.-lb; then connect the gasline hose,
vacuum line, and throttle cable.
11. Place the air filter assembly into position and secure
with the self-tapping screws; then connect the intake
boot to the throttle body and the inlet housing boot to
the air filter housing. Tighten the clamps securely.
12. Place the shifter assembly into position and secure
with the four machine screws. Tighten securely.
13. Connect the shift cable to the shift arm; then secure
with the E-clip. On the XTX, connect the gear posi-
tion switch connector.
 NOTE: Before operating vehicle, check and adjust
shift cable as required (see Section 2).
3-50
14. Fill the engine/transmission with the appropriate
lubricant.
15. Remove the coolant bleed screw from the upper
coolant pipe near the thermostat; then pour the cor-
rect mixture of coolant into the radiator. When cool-
ant with no air bubbles flows from the bleed hole,
install the screw and tighten securely; then complete
filling the system.
PR154
16. Connect the positive battery cable to the battery; then
connect the negative cable.
17. Install the left-side and right-side seat-bases; then install
the center console and seats. Make sure the seats lock
securely.
18. Start the engine and warm up to operating temperature.
Check for fluid leaks; then shut off engine and check oil
and coolant levels (see Section 2 and Section 4).
PR819A