Arctic Cat 2013 Prowler XT Service Manual page 85

3. Remove the cap screws securing the valve cover to
the head; account for the four rubber washers on the
top side cap screws. Remove the valve cover.
Account for and note the orientation of the camshaft
plug. Note the location of two alignment pins.
4. Remove the cap screw on the end of the tensioner;
then using a flat-blade screwdriver, turn the tensioner
clockwise to remove the tension. Remove the two
cap screws securing the tensioner adjuster assembly
and remove the assembly. Account for a gasket.
3-58
5. Using an awl, rotate the C-ring in its groove until it is
out of the cylinder head; then remove the C-ring.
 NOTE: Care should be taken not to drop the C-ring
into the crankcase.
GZ126A
GZ162
6. Bend the washer tabs down and remove the two cap
screws securing the sprocket to the camshaft; then
drop the sprocket off the camshaft being careful not
to drop the locating pin into the engine.
GZ403A
7. While holding the chain, slide the sprocket and cam-
shaft out of the cylinder head.
GZ200
GZ155
GZ154A