Arctic Cat 2013 Prowler XT Service Manual page 197

3. Using a socket and ratchet handle, tighten the nut
until the stud is fully drawn into the hub.
INSTALLING
1. Secure the brake disc (if applicable) to the hub with
the four cap screws coated with red Loctite #271.
Tighten to 15 ft-lb.
2. Apply grease to the splines in the hub.
3. Install the hub assembly onto the axle; then set the
parking brake.
6-24
PR250
4. Secure the hub assembly with the nut. Tighten to 200
ft-lb; then secure with a new cotter pin.
 NOTE: If the cotter pin can not be inserted due to
misalignment of the hole in the axle and the slots in
the nut, tighten the nut until properly aligned.
PR252A
5. For front hubs, secure the brake calipers to the
knuckle with two new "patch-lock" cap screws tight-
ened to 20 ft-lb.
PR254B
6. Install the wheel and tighten in a crisscross pattern in
20 ft-lb increments to 80 ft-lb (aluminum wheels) or
45 ft-lb (steel wheels).
7. Remove the vehicle from the support stand.
PR221
PR258
PR377B