Arctic Cat 2013 Prowler XT Service Manual page 111

INSPECTING CENTRIFUGAL
CLUTCH SHOE
Inspect the clutch shoes for wear or damage. If any shoe
is worn to the bottom of the groove, replace the clutch
assembly.
INSPECTING CLUTCH HOUSING
1. Inspect the clutch housing for burns, grooving,
cracks, or uneven wear.
2. If the housing is damaged in any way, the housing
must be replaced.
INSPECTING PRIMARY
ONE-WAY DRIVE
1. Insert the drive into the clutch housing.
2. Rotate the inner race by hand and verify the inner
race rotates only one direction.
3. If the inner race is locked in place or rotates both
directions, the drive assembly must be replaced.
DRIVEN PULLEY ASSEMBLY
 NOTE: The driven pulley is a non-serviceable com-
ponent. If the pulley faces, cam ramps, or face bush-
ing are worn or loose, the pulley must be replaced as
an assembly. Do not disassemble the driven pulley.
WATER PUMP DRIVE ASSEMBLY
 NOTE: Certain models have been built using an
external water pump drive assembly. When perform-
ing service procedures on the water pump, the tech-
nician should use sound judgment in determining
which type of pump is being serviced.
Disassembling
1. Remove the two snap rings from the driveshaft; then
remove the gear and drive pin noting the orientation
of the gear for proper assembly.
3-84
2. Remove the snap ring securing the bearing in the
water pump drive cover; then remove the bearing
using an appropriate blind bearing remover.
ATV1014
Inspecting
1. Inspect the water pump drive housing (A) for scoring
or discoloration.
2. Inspect the bearing (B) for smooth rotation and no
discoloration or scoring.
3. Inspect the gear (C) for chipped or missing teeth,
excessive hub wear, or excessive wear in the drive
pin slot.
4. Inspect the drive pin (D) and driveshaft (E) for
excessive wear or looseness.
Assembling
1. Install the bearing in the water pump drive cover and
secure with the snap ring (flat side away from the
bearing).
GZ442
GZ441
GZ440A