Arctic Cat 2013 Prowler XT Service Manual page 52

6. Remove the two cap screws securing the water pump
to the engine; then remove the water pump.
 NOTE: The water pump is not a serviceable compo-
nent. If the pump is defective or if the mechanical
seal is leaking (coolant dripping from the discharge
hole), the water pump must be replaced (see Section
4).
7. Remove the cap screws securing the right-side cover
to the crankcase noting the location of the differ-
ent-sized cap screws for installing purposes.
8. Using a side case puller, remove the side cover.
Account for a gasket and two alignment pins.
 NOTE: Inspect the inside of the right-side cover for
any shaft washers that may have come off with the
cover. Make sure they are returned to their respective
shafts and the starter idler gear spacer is on the shaft
or in the cover.
9. Remove the nut securing the magneto rotor to the
crankshaft; then install the magneto rotor puller
adapter.
 NOTE: The puller has left-hand threads.
10. Using Magneto Rotor Remover Set with appropriate
crankshaft protector, remove the rotor/flywheel
assembly from the crankshaft. Account for the key;
then remove the starter clutch gear assembly and
washer.
CD214
11. Remove the two starter gears from the crankcase not-
ing the direction of the beveled side of the gears for
installing purposes; then remove the two starter gear
shafts.
CF075A
CD939A
3
CD940A
CD136
CD140
3-25