Arctic Cat 2013 Prowler XT Service Manual page 189

6. While holding the drive axle stationary, pull the top
of the knuckle out and down until it is free of the
drive axle.
7. Place a drain pan under the vehicle to contain any oil
leakage; then pushing the axle shaft in, pull the axle
assembly from the gear case.
REMOVING FRONT DRIVE AXLE
 NOTE: For removing a front drive axle, see Front
Differential in this section.
CLEANING AND INSPECTING AXLES
 NOTE: Always clean and inspect the drive axle com-
ponents to determine if any service or replacement is
necessary.
1. Using a clean towel, wipe away any oil or grease
from the axle components.
6-16
PR220A
2. Inspect boots for any tears, cracks, or deterioration.
 NOTE: If a boot is damaged in any way, it must be
replaced with a boot kit.
DISASSEMBLING AXLES
1. Using a side-cutters (or suitable substitute), remove
the large clamp from the boot.
PR218
2. Wipe away excess grease to access the retaining ring.
Using an awl or circlip pliers, remove the circlip.
PR729B
3. Using a snap ring pliers, remove the snap ring secur-
ing the bearing ring to the shaft. Note the direction of
the bearing for assembling purposes.
CD019
CD020
CD021