Arctic Cat 2013 Prowler XT Service Manual page 186

5. Making sure the O-ring is properly positioned on the
differential housing cover assembly, install the cover
with existing cap screws (coated with green Loctite
#270). Account for the ID tag. Tighten the cap
screws evenly to 23 ft-lb.
 NOTE: Grease can be applied to the O-ring for ease
of assembling.
 NOTE: If a new housing is being installed, tighten
the cap screws to 28 ft-lb.
6. Install the shift fork shaft w/spring into the housing
making sure the shaft O-ring is positioned to the
inside.
7. Install the shift fork assembly making sure the fork
leg is facing upward. Apply a small amount of oil to
the gasket; then install the gasket.
8. Place the input shaft assembly onto the gear case
housing; then secure with the existing cap screws.
Tighten to 23 ft-lb.
 NOTE: If a new housing is being installed, tighten
the cap screws to 28 ft-lb.
CF275A
Removing/Installing Axle Seal
 NOTE: This procedure can be performed on a rear
gear case.
1. Remove the seal using a seal removal tool.
CC892
 NOTE: Prior to installing the seal, apply High-Per-
formance #2 Molybdenum Disulphide grease to the
seal outside diameter.
2. Using Gear Case Seal Installer Tool, evenly press the
seal into the cover bore until properly seated.
CC893
CD103
CD110
6
CC899
6-13