Arctic Cat 2013 Prowler XT Service Manual page 63

5. Grease the driven gear pin and insert it into the oil
pump shaft; then install the driven gear (noting the
direction of the sides of the gear from removing).
Secure with a snap ring.
 NOTE: When installed correctly, the sides of the
drive and driven gears will be flush with each other.
3-36
6. Install the clutch shoe assembly and secure with the
flange nut (threads coated with red Loctite #271).
Tighten to 221 ft-lb.
CD992
7. Install the clutch cover alignment pins into the crank-
case, apply oil to the cover gasket, and install the
gasket onto the crankcase.
8. Install the one-way clutch onto the clutch shoe
assembly.
CD991
When installed correctly, the green dot (or the word
OUTSIDE) on the one-way clutch is visible.
9. Lightly grease the clutch housing seal; then insert the
left fixed drive spacer.
CD985A
CD984
CAUTION
PR410A
PR399A
CF088A