Arctic Cat 2013 Prowler XT Service Manual page 194

4. If clearance is not as specified, repeat steps 1 and 2
using thicker (clearance too great) or thinner (clear-
ance too small) until correct specification is reached.
REAR DRIVE INPUT SHAFT/
HOUSING
Removing/Disassembling
1. Remove the cap screws securing the rear drive input
shaft/housing to the rear gear case; then remove the
input housing assembly.
2. On the XTZ model, remove the clutch pack from the
clutch basket; then remove the snap ring securing the
clutch basket (A) to the input shaft (B) and remove
the clutch basket.
3. Remove the input shaft from the input housing; then
remove the oil seal.
GZ183
GZ392
4. Remove the snap ring retaining the input bearing and
using an appropriate bearing driver, press the bearing
from the housing.
GZ176A
GZ177
GZ180
6
GZ182A
GZ184A
6-21