Arctic Cat 2013 Prowler XT Service Manual page 80

CAUTION
The gear position switch wires are secured to the frame
with a nylon tie connector. This must be removed prior
to removing the engine/transmission or harness dam-
age will occur.
11. Remove four mounting cap screws securing the shift
support assembly to the frame; then remove the cap
screw securing the upper coolant pipe support clamp
to the shift support.
12. Remove the machine screw securing the throttle arm
cover; then loosen the mounting nuts and disconnect
the throttle cable from the throttle body.
PR658A
13. Remove the E-clip from the transmission shift arm;
then remove the shifter cable mounting bracket from
the crankcase and move the shift support assembly
and cable to right side of the vehicle.
 NOTE: The parking brake cable does not need to be
disconnected.
14. Using a shop towel to absorb any spilled gasoline,
remove the "quick-disconnect" fuel couplers from
PR596A
the fuel injectors.
PR598A
Always make certain the battery is disconnected and
the ignition key is removed before disconnecting fuel
system components. Gasoline could be accidentally
discharged by an activated fuel pump causing severe
injury or death.
15. Remove four sheet metal screws securing the air fil-
ter mounting bracket to the frame; then loosen the
intake boot clamp and remove the air filter assembly.
! WARNING
PR666A
3
PR662A
PR663A
3-53