Arctic Cat 2013 Prowler XT Service Manual page 107

6. Install the shift cam stopper spring onto the shift cam
stopper and secure with a flat washer and flange nut.
Tighten to 8 ft-lb.
7. Install the shift cam plate onto the shift cam shaft and
secure with the cap screw. Tighten to 8 ft-lb.
8. Install the shift shaft into the crankcase making sure
the washers are properly located; then align the tim-
ing reference marks and completely seat the shift
shaft.
3-80
GZ256
9. Apply grease to the lips of the shift shaft seal in the
shifter housing; then using a new gasket, install the
shifter housing and secure with the cap screws.
GZ259
Tighten in a crisscross pattern to 8 ft-lb.
10. Install the spacer washer on the crankshaft; then
GZ260
install the starter ring gear.
GZ258
GZ261
GZ262
GZ249