Arctic Cat 2013 Prowler XT Service Manual page 179

4. Using a seal removal tool, remove the input shaft
seal. Account for a spacer.
5. Remove the snap ring securing the input shaft bear-
ing; then place the pinion housing in a press and
remove the bearing.
6-6
Assembling Input Shaft
1. Place the pinion housing in a press and install the
input shaft bearing. Secure the bearing with the
existing snap ring making sure the sharp edge of the
snap ring faces to the outside.
GC010
GC011
2. Install the input shaft seal making sure it is fully
seated in the edge of the housing.
AF984
3. Lubricate the input shaft with High-Performance #2
Molybdenum Disulphide Grease packing the boot
ribs and splines; then assemble allowing excess
grease to freely escape. Slight pressure on the boot
will be present during assembly. Secure with new
clamps.
 NOTE: Any time drive splines are separated, clean
all splines with parts-cleaning solvent and dry with
compressed air; then lubricate with recommended
grease.
KX219
GC012
GC011
GC014