Arctic Cat 2013 Prowler XT Service Manual page 54

REPLACING STARTER CLUTCH
ASSEMBLY
1. Remove the cap screws securing the one-way
clutch assembly to the flywheel; then remove from
the flywheel.
2. Thoroughly clean the rotor/flywheel; then install
the new one-way clutch and secure with the cap
screws after applying a drop of red Loctite #271 to
the threads. Tighten to 26 ft-lb using a crisscross
pattern. Make sure the one-way bearing is installed
with the notches directed away from the rotor/fly-
wheel.
FI572
REPLACING STARTER GEAR
BEARING
1. Support the starter clutch gear in a press making sure
to support the hub around the entire circumference;
then using a suitable bearing driver, press the bearing
from the gear.
FI570
2. Thoroughly clean the gear hub; then apply a drop of
green Loctite #620 to the bearing outer race and
press into the gear hub until even with the lower
chamfer radius.
INSPECTING STATOR/MAGNETO
COVER ASSEMBLY
FI576A
1. Inspect the stator for burned or discolored wiring,
broken or missing hold-down clips, or loose cap
screws.
FI578
3
FI583
FI580
3-27