Arctic Cat 2013 Prowler XT Service Manual page 103

7. Remove the two cap screws securing the water pump
to the crankcase; then remove the water pump.
Account for an O-ring.
 NOTE: The water pump is a non-serviceable compo-
nent and must be replaced as a complete assembly.
8. Remove the cap screws securing the gear shift cover
to the crankcase; then remove the gear shift cover.
Account for a gasket and washer.
 NOTE: Inspect the inside of the left-side cover for
any shaft washers that may have come off with the
cover. Make sure they are returned to their respective
shafts.
9. Remove the nut (A) from the shift cam stopper (B);
then remove the cam stopper spring (C). Account for
a flat washer (D).
3-76
10. Remove the cap screw securing the shift cam plate to
the shift cam shaft and remove the shift cam plate;
then remove the shift shaft. Account for a washer.
GZ230A
11. Remove the cap screws securing the speed sensor
housing to the crankcase and remove the housing
assembly; then remove the snap ring securing the
speed sensor trigger to the shaft and remove the trig-
ger using a suitable "two-jawed" puller. Account for
a gasket.
GZ231A
GZ233A
GZ236A
GZ234B
GZ243