Arctic Cat 2013 Prowler XT Service Manual page 223

9. Remove the snap ring securing the bearing in the
knuckle; then press the bearing out of the knuckle.
CLEANING AND INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Clean all knuckle components.
2. Inspect the bearing for pits, scoring, rusting, or pre-
mature wear.
3. Inspect the knuckle for cracks, breaks, or galling of
the bearing surface.
ASSEMBLING AND INSTALLING
1. Using a suitable press and driver, press the bearing
into the knuckle until firmly seated; then install the
snap ring.
8-12
2. Install the knuckle to the upper and lower ball joints
and secure with the two cap screws. Tighten to 35
ft-lb.
PR289
3. Install the tie rod end and secure with the nut (coated
with red Loctite #271). Tighten to 30 ft-lb; then
install a new cotter pin and spread the pin.
 NOTE: During assembling, new cotter pins should
be installed.
4. Apply a small amount of grease to the hub splines.
PR292A
5. Install the hub assembly onto the splines of the shaft.
PR289
PR202
PR203
PR290A