Arctic Cat 2013 Prowler XT Service Manual page 36

 NOTE: Keep the mounting hardware with the covers
for assembly purposes or thread them back into the
head to keep them separated.
2. Remove the 12 cap screws securing the valve cover
to the head; account for the four rubber washers on
the top side cap screws. Remove the valve cover.
Account for and note the orientation of the cylinder
head plug. Note the location of two alignment pins.
CC001D
3. Loosen the cap screw on the end of the tensioner;
then remove the two cap screws securing the ten-
sioner adjuster assembly and remove the assembly.
Account for a gasket.
4. Using an awl, rotate the C-ring in its groove until it is
out of the cylinder head; then remove the C-ring.
 NOTE: Care should be taken not to drop the C-ring
down into the crankcase.
CD205
CD206
5. Bend the washer tabs down and remove the two cap
screws securing the sprocket to the camshaft; then
drop the sprocket off the camshaft.
CD211A
3
CC009D
CC012D
3-9