Arctic Cat 2013 Prowler XT Service Manual page 49

18. Rotate the crankshaft until the second cap screw
securing the sprocket to the camshaft can be
installed; then install the cap screw (threads coated
with red Loctite #271) and tighten to 11 ft-lb. Bend
the tab to secure the cap screw.
19. Rotate the crankshaft until the first cap screw (from
step 17) can be addressed; then tighten to 11 ft-lb.
Bend the tab to secure the cap screw.
20. Place the C-ring into position in its groove in the cyl-
inder head.
3-22
CD464
21. Install the cylinder head plug in the cylinder head
with the open end facing downward and toward the
inside.
The open end of the plug must be positioned downward.
CD465
22. Remove the cap screw from the end of the chain ten-
sioner; then using a flat-blade screwdriver, rotate the
adjuster screw inside the tensioner clockwise until
the screw bottoms.
CD466
 NOTE: The adjuster shaft will be drawn into the ten-
sioner as the adjuster screw is rotated clockwise. The
adjuster shaft tension will be released in step 24.
23. Place the chain tensioner adjuster assembly and gas-
ket into position on the cylinder and secure with the
two cap screws.
CAUTION
CC012D
GZ162A
CD501