Arctic Cat 2013 Prowler XT Service Manual page 129

4. Secure the rear universal joint flange to the output
drive flange and tighten the four cap screws to 40
ft-lb.
5. Lubricate the splines on the front driveshaft with
multi-purpose grease; then align the match marks
and install the driveshaft into the front output joint.
6. Align the match mark on the front drive flange to
mark on the front universal joint flange and secure
with three cap screws. Tighten to 40 ft-lb and slide
the rubber boot back into position.
3-102
PR630
7. Install a new grafoil gasket in the rear cylinder head;
then place the rear exhaust pipe into position and
loosely secure with two cap screws.
PR647
8. With a new grafoil gasket in the front cylinder head
and a new grafoil seal on the exhaust pipe, install the
front exhaust pipe and loosely secure with two cap
PR639
screws.
PR638A
PR640
PR641A