Arctic Cat 2013 Prowler XT Service Manual page 133

24. Install nylon cable ties at all locations marked prior
to removing engine; then check for correct routing of
all wiring, hoses, and cables.
3-106
25. Connect the negative battery cable and install the
battery hold-down.
26. Pour the recommended amount of oil into the
engine/transmission.
27. Remove the coolant bleed screw from the upper
coolant pipe near the thermostat; then pour the cor-
rect mixture of coolant into the radiator. When cool-
ant with no air bubbles flows from the bleed hole,
install the screw and tighten securely.
PR594A
28. Start the engine and check for oil or coolant leaks;
then check all fluid levels and correct as necessary.
29. Wipe off any spilled coolant or lubricant; then install
the floor, storage console, seat bases, center console,
and seats.
PR592A
PR662A