Arctic Cat 2013 Prowler XT Service Manual page 79

6. Mark all cable tie locations with an appropriate
marker; then remove the ties.
7. Disconnect the negative battery cable; then from the
right side, disconnect the engine coolant temperature
(ECT) sensor (A), inlet air temperature (IAT) sensor
(B), fuel pump/fuel gauge connector (C), rear igni-
tion coil (D), and throttle position sensor (TPS) con-
nector (E).
3-52
PR590
8. Remove the rear spark plug cap; then from the left
side, remove the fuel injector connector (A), mani-
fold absolute pressure (MAP) sensor (B), parking
brake warning switch (C), reverse override switch
connector (D), and idle speed control (ISC) valve
(E).
PR591A
9. Disconnect the front ignition coil and remove the
front spark plug; then route the engine harness out of
the engine compartment.
PR592A
10. From the left rear, disconnect the speed sensor con-
nector (F), stator coil connector (G), crankshaft posi-
tion (CKP) sensor (H), and gear position switch
connector (I).
PR594A
PR595A
PR596