Code System Management - Teletek electronics CA60Plus Installation Manual

TeleTek

4. CODE SYSTEM MANAGEMENT

ADDRESS 40 SET WITH CODE
NO
YES
DEFAULT : NO
ADDRESS 41 USER CODE 1 ATTRIBUTES
1 Unset
2 FullSet
3 Part Set 1
4 Part Set 2
5 Log
6 Bypass
DEFAULT : UNSET, FULLSET, PART SET1, PART SET2, LOG, BYPASS
ADDRESS 42 USER CODE 2 ATTRIBUTES
DEFAULT : No
ADDRESS 43 USER CODE 3 ATTRIBUTES
DEFAULT : No
ADDRESS 44 USER CODE 4 ATTRIBUTES
DEFAULT : No
ADDRESS 45 USER CODE 5 ATTRIBUTES
DEFAUL]T : No
ADDRESS 46 USER CODE 6 ATTRIBUTES
DEFAULT : No
ADDRESS 47 MANAGER ACCESS TO THE USER CODE ATTRIBUTES
NO
YES
DEFAULT : YES
CA60Plus
Full or Partial arming of the area does not require confirmation by entering a
valid user code. The LEDs from 1 to 6 do not light.
Full or Partial arming of the area requires confirmation by entering a valid user
code. The LEDs from 1 to 6 light.
In this address the USER CODE1 attributes are set. The user code could have
more than one attribute. An attribute is activated/desactivated alternately by
pressing the digit of the respective number. The choice is indicated by lighting of
the LED with the number of the pressed digit. At the end of the procedure on
the display should light only the LEDs responding to the desired attributes.
Enables this user code to disarm the area.
Enables this user code to arm the area.
Enables this user code to arm PART1 of the area.
Enables this user code to arm PART2 of the area.
Gives this user code an access right to the event memory.
Gives this user code a right to bypass zones in the secured area.
Programming as in address 41.
Programming as in address 41.
Programming as in address 41.
Programming as in address 41.
Programming as in address 41.
The access of the manager to the user codes rights is denied.
The LEDs from 1 to 6 do not light.
The access of the manager to the user codes rights is allowed.
The LEDs from 1 to 6 light.
20
Installation Manual