Selecting The Video Output Signal Format; Setting The Pgm Output Aspect Ratio - Sony AWS-G500 Operating Instructions Manual

Selecting the Video Output Signal Format

Setting the PGM Output Aspect Ratio

52 Installation/Default Settings
1
LCD Backlight
Viewer Priority PGM
File TC Off
4
Press the MENU button to close the menu.
Select the format for the signals output from the PGM output connectors
(COMPOSITE/S VIDEO), the SD video interface module's DV connectors, and
the SDI output, HD analog output, HD SDI output, and reference output
connectors on the rear panel.
1
Press the MENU button.
2
In the top menu, select [Video Output].
3
1 Select [PGM OUT], and confirm; 2 select the signal format, and confirm.
1
PGM OUT NTSC/60Hz B NTSC/60Hz
PGM OUT Aspect 4:3 PAL/50Hz
PGM OUT Level
A confirmation message appears.
4
Press the ENTER button.
A shutdown message appears, and the system shuts down.
Caution
• Carrying out this selection may cause momentary breakup of the output video.
• When [PAL/50Hz] is selected, small portions of the top and bottom of PAL
input videos will be missing. To avoid this, set the RGB output signal format
to [Video RGB] (page 216).
Note
Video input in a different signal format than this setting can still be displayed
(i.e., displaying a PAL video input when set to "NTSC" or vice versa), but the
video quality cannot be guaranteed.
Select the size (ratio between width and height) of the program output video.
1
Press the MENU button.
2
In the top menu, select [Video Output].
3
1 Select [PGM OUT Aspect], and confirm; 2 select a size for the program
output video, and confirm.
2
2