Table of Contents
Advertisement
When using the HD SDI output connector
Setting the HD output signal format (when using an HD video interface module or
HD serial digital interface module)
194
Recording Video and Audio to a VCR
Procedure for recording on a VCR
Program video is always output as HD analog signals from the HD analog output
connector.
Connect the VCR to the HD analog output connector, and operate the VCR to
start recording.
Note
Recording is possible when the PGM output aspect ratio setting is 16:9 HD.
When recording is possible, the HD indicator to the left of the HD analog output
connector is lit.
When an HD serial digital interface module is installed on the unit, you can
record program output by connecting a VCR that supports HD SDI input to the
HD SDI output connector (HD SDI OUT).
Procedure for recording on a VCR
Program video and audio are always output as HD SDI signals from the HD SDI
output connector.
Connect the VCR to the HD SDI output connector, and operate the VCR to start
recording.
Note
Recording is possible when the PGM output aspect ratio setting is 16:9 HD.
When recording is possible, the HD indicator to the left of the HD SDI output
connector is lit.
Select the format for the signal output from the HD analog output connector when
the PGM output aspect ratio is set to 16:9 HD.
1
Press the MENU button.
2
In the top menu, select [Video Output].
3
1 Select [HD OUT], and confirm; 2 select a signal format, and confirm.
1
PGM OUT
NTSC/60Hz
B 1080i
PGM OUT Aspect
16:9 HD
720p
PGM OUT Level
RGB OUT
SXGA (60Hz)
HD OUT
[1080i]: Outputs 1080 interlace signals.
[720p]: Outputs 720 progressive signals.
For more on the NTSC (60 Hz) and PAL (50 Hz) setting, see "Selecting the
Video Output Signal Format" (page 52).
4
Press the MENU button to close the menu.
2
Advertisement
Table of Contents
