Table of Contents
Advertisement
Registering Cue-Up Points
Naming cue-up points
Caution
If the version of the software used to record the file is prior to 1.40, a timecode
starting at 00:00:00:00 is always displayed at the beginning of the file even if
[File TC] is set to [On].
If you register any position of the file to one of the numeric buttons from 1 to 6,
you can access that position by simply pressing that numeric button.
1
Open the file.
For details on opening files, see "Playing Files" (page 181).
2
Play to the position to be cued up.
3
In the HDD file guide menu, 1 select the number to register the cue-up point
to, and confirm; 2 select [Preset], and confirm.
Example: When registering to numeric button [2].
1
File Open
Preset
z
z
File Close
SHIFT
+
Delete
1
Data Name
2
3
4
5
6
The cue-up point is registered to the corresponding numeric button on the
front panel.
Note
You can also register the point by pressing numeric button [2] while holding
down the SHIFT button.
The cue-up point is registered and the timecode of the position to be cued up
is displayed.
File Open
File Close
SHIFT
z
+
z
1
2 00:04: 00: 00
3
4
5
6
Note
To change the position to be cued up, repeat steps 2 and 3 above.
1
Open the file in which the cue-up point is registered.
2
SHIFT
z
+2
[
]
Operations on Files on the External Hard Disk
187
Advertisement
Table of Contents
