Table of Contents
Advertisement
Starting program output recording
Stopping of program output recording
Manually Recording Each Input Material on an External Hard
Disk
178
Recording Video and Audio to an External Hard Disk
Signal format
Same as the setting of [PGM OUT] of [Video Output] in the top menu.
(NTSC/PAL)
Timecode
System timecode (page 54)
1
Configure the settings in "Preparing for Recording to an External Hard Disk"
(page 174).
2
Press the PLAY button while holding down the SHIFT and REC buttons.
PLAY button
"REC PAUSE" appears in the hard disk status display of the PGM viewer
and the following confirmation message appears.
3
Press the ENTER button or PLAY button.
The hard disk status indication changes to "REC," and recording starts.
Press the STOP button while holding down the SHIFT and REC buttons to stop
recording.
On an external hard disk connected to the i.LINK connector (HDD) of the
interface module, you can manually record video inputted to the same interface
model in combination with audio that has the same source number as the video.
Use this function if ON LINE recording did not start for some reason or if you
want to start recording material again afterwards.
Furthermore, you can simultaneously record two inputs of the interface module
to one external hard disk.
For details of formatting an external hard disk, see "Formatting an External
Hard Disk" (page 172).
Caution
It is not possible to record the material with an external recorder connected to the
i.LINK connector (HDD).
MENU
X - Y
REC button
REC
SHIFT button
SHIFT
Advertisement
Table of Contents
