Table of Contents
Advertisement
Problem
External hard disk
The hard disk number does not
appear in the source viewer.
Attempts at recovery yield
repeated messages, "An error
occurred while recovering."
The [PGM Recording] menu
does not appear.
The hard disk number remains
grayed out.
HD video interface module or HD serial digital interface module
The HD indicator does not light.
Keyboard
The keyboard does not work.
Possible causes
The source viewer is set to "No
Assign."
The source viewer shows "No
Interface Module."
The hard disk is not recognized.
Program output recording is
reserved.
The DV connector is set for
program output recording.
The hard disk data is
unrecoverable.
The aspect ratio is set to 16:9 HD
mode.
The hard disk is being recovered
automatically.
The aspect ratio is not set to 16:9
HD mode.
The keyboard is out of range of
the infrared sensor.
The keyboard batteries are
depleted (when the keyboard is
detached for use).
Possible solutions
Set the input with [Video Input
Assign] on the top menu.
Connect the interface module
correctly.
Disconnect the cable, then
reconnect, and restart this unit.
Set [PGM Recording] of [ON
LINE Manager] in the top menu
to [Off].
Set [PGM Output] of [DV OUT]
of [Video Output] in the top
menu to [Off].
Use [File Manager] on the top
menu t [Format].
* This erases the data.
Set to 4:3 or 16:9 SD mode.
If the hard disk number does not
display properly after waiting a
few moments, restart the unit.
Set to 16:9 HD mode.
Use the keyboard within range of
the infrared sensor.
Replace the batteries.
See
page
67
65
178, 189
175
191
172
52
–
25, 52
48
47
Troubleshooting
297
Advertisement
Table of Contents
