Sony AWS-G500 Operating Instructions Manual page 168

168 Using the FACTORY USE Connector
Pin Signal
I/O
Number Name
5 I GPI4
6 I GPI5
7 - GND
8 - GND
9 O GPO0
10 O GPO1
11 O GPO2
12 O GPO3
13 O GPO4
14 - GND
15 - GND
Caution
Because the GPO of the FACTORY USE connector on the unit has a built-in
protection circuit, it may not operate properly depending on the input circuit
configuration of the device to be connected.
Refer to the following diagram to prepare the cables.
Sample circuit diagram (CCU-D50/CCU-M7/CCU-M5/HFU-X310)
10000 pF
NOISE FILTER
RSB6.8SFTE
~
Vz=±5.78 V 7.82 V
AWS-G500
* When using an HFU-X310, couple directly without using a diode.
Description
GPI IN5: Switches to the PGM or NEXT selection button
assigned to source number 5.
5V TTL
GPI IN6: Switches to the PGM or NEXT selection button
assigned to source number 6.
5V TTL
GROUND
GROUND
GIP OUT1: Controls the tally of the camera assigned to
source number 1.
On: GND; Off: Open
GIP OUT2: Controls the tally of the camera assigned to
source number 2.
On: GND; Off: Open
GIP OUT3: Controls the tally of the camera assigned to
source number 3.
On: GND; Off: Open
GIP OUT4: Controls the tally of the camera assigned to
source number 4.
On: GND; Off: Open
GIP OUT5: Controls the tally of the camera assigned to
source number 5.
On: GND; Off: Open
GROUND
GROUND
Vcc
Zener diode
(Vz=3.2 V~7.42 V)*
Cable Connected device
* For details on other device
models, consult your
R dealer or your Sony
service representative.