Sony AWS-G500 Operating Instructions Manual page 192

192 Recording Video and Audio to a VCR
• When the PGM output aspect ratio is set to 16:9 HD, output from a DV
connector is not available.
1
Connect the VCR to the DV connector.
Note
Depending on the model of VCR, signal input/output settings may be
required. Refer to the Operating Instructions for the device to be connected.
2
Press the MENU button.
3
In the top menu, select [Video Output].
4
1 Select [DV OUT], and confirm; 2 select [PGM Output], and confirm;
3 select the DV connector to which the VCR is connected from the list, and
confirm.
1
PGM OUT NTSC/60Hz PGM Output
PGM OUT Aspect 4:3 Audio Mode
PGM OUT Level
DV OUT
RGB OUT SXGA (60 Hz)
Add TC
Add Aspect ID Off
Filter Mode
This sets the selected DV connector for program output, and program video
is output.
Notes
• At this point, the selected DV connector is grayed out and unavailable in
the [Video Input Assign] menu and [Audio Input Assign] menu.
• When an external hard disk is connected to an i.LINK connector of the
same interface module as the selected DV connector, the hard disk status
of the source viewer assigning images from each of the input connectors
on that module disappears.
5
1 Select [Audio Mode], and confirm; 2 select the audio sampling rate for
the program output, and confirm.
1
PGM OUT NTSC/60Hz PGM Output
PGM OUT Aspect 4:3 Audio Mode
PGM OUT Level
DV OUT
The functions of the setting items are as follows.
Fs32kHz(4ch): 12 bit, 32 kHz sampling, 4-channel output (select this item
if you want to later record to channels 3 and 4 on a device with an audio
dubbing function).
The audio output is as follows.
1 ch: L
2 ch: R
3 ch: L (the same 1 ch)
4 ch: R (the same 2 ch)
Fs48kHz(2ch): 16 bit, 48 kHz sampling, 2-channel output
2 3
Off B Off
Fs48kHz(2ch) SLOT1 OUT1 DV
OUT2 DV
SLOT2 OUT1 DV
OUT2 DV
SLOT3 OUT1 DV
OUT2 DV
2
SI-2 DV Fs32kHz(4ch)
Fs48kHz(2ch) B Fs48kHz(2ch)