Adjusting The Output Using The Oscillator Signal - Sony AWS-G500 Operating Instructions Manual

Adjusting the Output Using the Oscillator Signal

• Video displayed on the PGM viewer lags several frames behind the video
output from the PGM video output connectors.
6
Press the MENU button, to close the menu.
This is for setting the output oscillator signal for use during adjustment.
1
Press the MENU button.
2
In the top menu, select [Audio Utility].
3
Select [OSC], and confirm, and set the oscillator signal output.
Setting the oscillator signal frequency
1 Select [OSC Freq.], and confirm; 2 select the frequency from the
submenu, and confirm.
Audio Monitor OSC Freq.
OSC OUT Level
TB OSC OUT
Note
When the output destination is set with [OSC OUT], and a selection other
than [Off] is made, the DIM button lights, and the levels of the internal
speakers, the headphones, and monitor outputs are automatically reduced.
Setting the oscillator signal output level
1 Select [OUT Level], and confirm; 2 adjust the output level with the
slider.
Audio Monitor OSC Freq.
OSC OUT Level
TB OSC OUT
Setting the oscillator signal output destination
1 Select [OSC OUT], and confirm; 2 select the output destination to
output the oscillator signal, and confirm.
Audio Monitor OSC Freq.
OSC OUT Level
TB OSC OUT
Note
You can select multiple output destination.
4
Press the MENU button to close the menu.
1
2
Off
Off
-20dBFS B 100Hz
440Hz
1kHz
10kHz
1 2
Off
-20dBFS
1 2
Off PGM
-20dBFS s AUX1
s AUX2
s MIX
Video/Audio Signal Adjustments and Settings 223