Overview; Connecting Computer; Communication Format - Sony RS-232C Interface Manual

Overview

This is the Interface Manual for the Sony SRP-X700P Digital Powered Mixer. This protocol is designed to control the SRP-X700P Digital
Powered Mixer from an externally connected computer. Read this manual together with Operating Instructions.
Caution
The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the
purchasers of the equipment described in this manual.
Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation
or maintenance of the equipment described in this manual without the express written permission of Sony Corporation.
Numeric expression and nomenclature of character
The numeric values followed by [H] indicate the hexadecimal numbers. Other numeric values are the decimal values.
The characters surrounded by apostrophes (' ') indicate the hexadecimal numbers converted the by the ASCII code.

Connecting Computer

Connect the COM port of a computer to the REMOTE RS-232C terminal of the SRP-X700P Digital Powered Mixer.
The REMOTE RS-232C terminal of the SRP-X700P Digital Powered Mixer has the following specifications.
Terminal shape
Electrical specifications : Conforms to the RS-232C standard
Connection

Communication Format

The communication format is described below.
Baud rate
Communication mode
Data length
Parity
Stop bit
Flow control
: D-SUB 9-pins, male, inch-sized screws
:
Pin No.
1
2
3
4
5
6
7
8
9
SRP-X700P
REMOTE RS-232C terminal
Name Pin No.
RXD 2
TXD 3
GND 5
: 9600 bps
: Half-duplex start stop system (asynchronous)
: 8 bits
: Odd
: 1 bit
: None
Name
F.G
RXD
TXD
DTR
GND
DSR
RTS
CTS
OPEN
– 4 –
1 2 3 4 5
6 7 8 9
Computer COM port
(for D-SUB 9-pins male connector)
Pin No. Name
3 TXD
2 RXD
5 GND