Cutting High Frequency Or Low Frequency; Adjusting The Equalizer - Sony AWS-G500 Operating Instructions Manual

Cutting High Frequency or Low Frequency

Adjusting the Equalizer

Caution
When a file on an external hard disk is open, the adjustment value of [Input Trim]
is used for file playback.
This cuts high frequencies or low frequencies.
Use these settings to suppress noise.
Notes
• To cut high frequencies select [High Cut], and to cut low frequencies select
[Low Cut].
• You can set both [High Cut] and [Low Cut].
1
Press the ACCESS button in the same column as the channel fader to which
the audio you want to adjust is assigned.
2
1 In the top menu, select [Filter]; 2 select [High Cut (8kHz)] or [Low Cut
(100Hz)].
1
Input Trim 0dB High Cut (8kHz)
Filter Off Low Cut (100Hz)
EQ Off
Limiter/Compressor Off
3
Press the ESC button to close the ACCESS menu.
You can adjust the audio quality by using the equalizer to set frequencies in the
high, middle, and low audio ranges.
1
Press the ACCESS button in the same column as the channel fader to which
the audio you want to adjust is assigned.
2
1 In the top menu, select [EQ]; 2 select [On], and confirm.
1
Input Trim 0dB Off
Filter On
EQ Off High Freq.
Limiter/Compressor Off High Level
Pan CNT Middle Freq.
PGM OUT On Middle Level
AUX1 OUT Off Low Freq.
AUX2 OUT Off Low Level
2
2
XXkHz
XXdB
XXkHz
XXdB
XXkHz
XXdB
Video/Audio Signal Adjustments and Settings 219