How To Control The Display From The Srp-X700P; Projector Control Rs-232C Terminal; Projector Control Control S In/Out Terminal; How To Control The Srp-X700P From External Equipment - Sony SRP-X700P Operating Instructions Manual

How to Control the Display from the SRP-X700P

For the projectors that the SRP-X700P supports by default, refer to the "List of supported projectors" on a separate document.

PROJECTOR CONTROL RS-232C Terminal

To connect the RS-232C terminal of applicable projectors and that of plasma display to this terminal;
This model can switch the input signals and power ON/STANDBY of the projector and plasma display in interlocked condition.
<SRP-X700P side>
Pin No. Signal
1
2
3
4
5
6
7
8
9

PROJECTOR CONTROL CONTROL S IN/OUT Terminal

The SRP-X700P can switch the input signals and power ON/STANDBY of
the projector automatically when CONTROL S cable is connected to Sony's
projector as interlocked operation. The RGB signal and the component
signal cannot be connected at the same time for the interlocked operation.
Connect the wired remote commander supplied with a projector to the
CONTROL S IN terminal. Then you can establish various setups of a
projector from the SRP-X700P. If you want to use the wired remote
commander on battery, locally fabricate a connecting cord with STEREO
mini plug connected at one end, for supplying the power.

How to Control the SRP-X700P from External Equipment

Note
The USB terminal and the REMOTE USB terminal are the dedicated terminal to control this unit from the SRP-X700P Manager and User
Control Panel.

REMOTE RS-232C Terminal

Use of this terminal enables you to control the SRP-X700P from an external
controller.
Terminal shape : D-sub 9-pin, male (with inch-type screws)
Electrical specifications : Conforms to RS-232C standard
Recommended cable : Multi-core shielded cable for data communication
Cable length : 15 m or less
Communication format
Baud rate : 9600 bps
Bit length : 8 bits
Stop bit : 1 bit
Parity : ODD (odd number)
Note
Use the null modem cable when connecting the SRP-X700P with computer.
(D-sub 9-pin, male)
Function
FG Frame ground
RD Receive data
TD Send data
ER Not connected
SG Signal line ground
DR Not connected
RS Not connected
CS Not connected
N. C Not connected
<Sony projector/
plasma display side>
Pin No. Signal
1 FG
2 RX DA
3 TX DA
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
Remote
commander
Pin No.
1
2
3
4
5
6
7
8
9
(D-sub 9-pin, female)
Function
Frame ground
Receive data
Send data
Data terminal ready
Ground
Data set ready
Request to send
Clear to send
Called display
<SRP-X700P>
CONTROL S
PROJECTOR
IN
OUT
Signal Function
FG Frame ground
RD Receive data
TD Send data
ER Not connected
SG Signal line ground
DR Not connected
RS Not connected
CS Not connected
N. C Not connected
Projector
9